Resistance/Continuity Tests

Static Testing-Vehicle "OFF"

Static testing procedures allow for shop testing of the transaxie in the vehicle or on the bench. Completion of these tests prove out the transaxie electronically.

Caution: For resistance checks, be sure that the tester solenoid select switch is set to the "OHMS CHECK" position or damage to the ohmmeter may result.

Resistance/Continuity Tests

- Refer to Pinpoint Test to be performed "On Board Diagnostics" based on the DTC displayed.

- Using a volt-ohmeter and the transmission tester perform the Pinpoint Tests as indicated in "On Board Diagnostics" based on the DTC which were displayed.

- Perform repairs as indicated by the Pinpoint Tests. Always retest and road test vehicle after a repair.