Transmission Mode Switch: Service and Repair

1. Disconnect the negative battery cable.
2. Remove the front console.
3. Remove the indicator panel installation screws.
4. Disconnect the connector and remove the hold switch terminals.
5. Remove the selector lever knob assembly.
6. Install a new selector lever knob assembly.

Tightening torque: 2.0-2.9 N.m (20-30 kgf.cm, 18-26 in.lbf)

7. Install the hold switch terminals and connect the connector.
8. Install the indicator panel installation screws.
9. Install the front console.
10. Connect the negative battery cable.