Air Dam Skirt, Front - Loose

Bulletin No.: 020/94
Issued: 4/28/94
Revised: 7/10/94

Category
S

Applicable Models
1993-94 626/MX-6

Subject:
LOOSE FRONT AIR DAM SKIRT

The revised section of this bulletin is indicated by an asterisk (*). Replace the original bulletin with this revised copy.

APPLICABLE MODELS/VINS
All 1993 626/MX-6
1994 626/MX-6 - Vehicles with a VIN of 1YVGE .... R5170626 or lower

NOTE:
The asterisk (*) in the VIN can be any number (0 through 9) or "X".

DESCRIPTION*
The front air dam skirt may be loose at the front cross member. This is caused by loose or missing attaching grommets.The air dam skirt may remain attached by a single bolt. To prevent this problem, an additional bolt and weld nut are added during production.

REPAIR PROCEDURE

* Replace the factory installed grommets with aftermarket license plate nuts, screws and washers.

1. Insert nylon nuts into crossmember.





2. Place screw with washer through air dam skirt and secure into nylon nut. Refer to illustration.

PARTS INFORMATION

Mazda recommends the use of Auveco fasteners. These fasteners are available through Sarjo at 1-800-447-2766. Listed below are applicable part numbers.

Sarjo Part Number Description

8606 Flat Washer

9603 Screw

11719 Nylon Nut

WARRANTY INFORMATION
(Applies to vehicles covered under normal vehicle warranty)
Warranty Type: A
Symptom Code: 91
Damage Code: 9E
Part Number Main Cause: KA78 50 AF4
Quantity: 0
Operation Number: YYO162RX
Labor Hours: 0.3 Hrs. (Includes cost of aftermarket fasteners)