Rear Door

NOTE:
Door skin must be at least 60 degrees F.

1. Place the window in the full UP position.

2. Remove the inner door panel.

3. Carefully peel back the bottom half of plastic door screen (10 re-use).

4. Remove the affected molding (if attached to door).

5. Apply alcohol to a clean cloth and remove adhesive residue along the door molding area.

6. Remove the adhesive backing and install the molding.

NOTE:
Start at the front and work to the rear of the vehicle.





7. Install the remaining five (5) retainers onto the locator pins using a 10 mm deep well socket Refer to Fig. 4.

NOTE:
An retainers must be installed tight against the door skin.

8. Apply firm pressure to the molding to secure the adhesive to the door.

9. Carefully install.
^ Plastic door screen
^ Door Panel

10. Test all functions.