Mirrors, A Pillar - Wind Noise

Bulletin No.: 012/94
Issued: 3/16/94
Revised:

Category
S

Applicable Model/s
1993-94 626

Subject:
WIND NOISE AROUND SIDE MIRRORS AND "A" PILLAR

APPLICABLE MODELS
All 1993-94 626 models

DESCRIPTION





Wind noise may be heard around the side view mirrors and/or the "A" pillar. This noise is created as air travels over the gap or step of the belt line molding behind the side view mirror molding and/or the front window sash molding just above the side mirrors. Refer to the illustration.

REPAIR PROCEDURES
1. Verify that the forward portion of the belt line molding/sash molding is loose and/or detached from the front clip.
2. If detached, install the forward portion of the molding and glue the clipped area with clear silicone.
3. Eliminate the gap or step by filling the area with clear silicone.

NOTE:
Use only a minimal amount of silicone to perform steps 2 and 3. Remove any excess prior to customer delivery. To prevent the problem from reoccuring, the silicone must form a smooth gentle slope when dry.

WARRANTY INFORMATION
(Applies To Vehicles Covered Under Normal Warranty)
Type: A
Customer Comment Code: 82
Damage Code: 9H
Part Number Of Main Cause: GA2K 50 M20G(L), GA2K 50 M10F(R)
Quantity: 0
Operation Number: YY0139RX
Labor Hour: 0.3Hr.

NOTE:
Labor amount includes cost of clear silicone