17. Rear Control Valve Body

REAR CONTROL VALVE BODY DISASSEMBLY / INSPECTION / ASSEMBLY

CAUTION: Denting or scratching these precisely machined components will reduce the ability of the transaxle to shift properly. When handling these components or the valve body that contains them, be careful not to drop or hit them.

NOTE: If a valve does not slide out under its own weight, place the valve body open-side down and tap on the valve body lightly with a plastic hammer.





1. Disassemble in the order shown in the figure, noting the proper reassembly direction of the valves and internal parts.

WARNING: Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed air.

2. Clean all parts and bores with compressed air and apply ATF to them immediately before assembly.
3. Assembly in the reverse order of disassembly, referring to Assembly Procedure.

Spring Inspection





1. Measure the spring free length.





2. If not as specified, replace the spring.

Assembly Procedure





1. Install the 2-3 timing valve, 2-3 timing spring, 2-3 timing plug, and stop pin.





2. Install the pressure regulator valve, pressure regulator spring, pressure regulator spring seat, pressure regulator plug, pressure regulator plug sleeve, and stop pin.





3. Install the manual valve.