Displaying & Reading Trouble Codes
Inspection Procedure1. Connect the SST (System Selector) to the data link connector.
2. Set the SYSTEM SELECT switch A to position 2.
3. Set the TEST SW to SELF TEST position.
4. Connect the SST (Self-Diagnosis Checker) to the SST (System Selector) and a ground.
5. Set the SELECT SW to position A.
6. Turn on the ignition switch.
7. Verify that "88" flashes on the digital display and that the buzzer sounds for 3 seconds.
8. If "88" does not flash, check the main relay and 2S and 2Q terminals of the powertrain control module (transaxle) for an open or short circuit.
9. If "88" flashes and the buzzer sounds continuously for more than 20 seconds, check the wiring to terminal 1C of the powertrain control module (Transaxle) for an open or short circuit. If necessary, replace the powertrain control module (Transaxle) and repeat from step 2.
10. Note any code number(s) and check for the cause(s). Repair as necessary.
11. After repairs are made, do the After-Repair Procedure to verify that there are no remaining code numbers.