With Self-Diagnosis Checker and System Selector

Remove Negative Battery Cable To Clear Diagnostic Trouble Codes:

CLEARING CODES
1. Clear diagnostic trouble codes by disconnecting the negative battery cable, for at least 20 seconds, and depressing the brake pedal.
2. Reconnect the negative battery cable.

VERIFY ALL CODES CLEARED
1. Start and warm up the engine, then run it at 2,000 rpm for three minutes.
2. Turn engine off.

View: Special Service Tool (SST) System Selector:

3. Connect the special service tool (SST) (System Selector) to the data link connector.
4. Set the switch A to position 1.
5. Set TEST SW to SELF-TEST.

View: Test Connections:

6. Connect the SST (Self-Diagnosis Checker) to the System Selector and a ground.

View: Special Service Tool (SST) Self-Diagnosis Checker:

7. Set the select switch of the Self-Diagnosis Checker to position A.
8. Turn the ignition switch ON.
9. Verify that no code numbers are displayed.