Brake Signal: Testing and Inspection

PREPARATION
Connect the special service tools (SST) to the powertrain control module engine (PCME).

SST Engine Signal Monitor-49 9200 162 And Harness Adapter-49 G018 903:

1. Connect the SST engine signal monitor between the PCME and the vehicle's PCME connector by using the SST adapter harness.

SST Sheet Overlay-49 G018 904:

2. Place the SST engine signal sheet overlay on the SST engine signal monitor.
3. Turn ignition switch ON.
4. Measure voltage at terminal 2L.

Condition:--Brake pedal released.
Voltage:--Below 1.0 Volt.

Condition:--Brake pedal depressed.
Voltage:--Battery voltage.

If readings are not as shown, then inspect the stoplight switch, the wiring between the stoplight switch and PCME terminal 2L.