Fuel Pressure Regulator Control Inspection
Pressure Regulator Control System:
SYSTEM OVERVIEW
SYSTEM INSPECTION
1. Start the engine and run it at idle.
2. Disconnect each vacuum hose from the pressure regulator. Verify that vacuum is felt.
View: Grounding The Pressure Regulator Control Solenoid Valve:
3. Ground the pressure regulator control (PRC) solenoid valve terminal wire by using a jumper wire. Verify that NO vacuum is felt to vacuum hose A and B.
4. If vacuum exists, check the PRC solenoid valve.
5. Connect the vacuum hose A and B.
View: Grounding The Pressure Regulator Control Solenoid Valve No.2:
6. Ground the terminal wire for PRC solenoid valve No. 2 by using a jumper wire. Verify that vacuum is felt to vacuum hose B and NO vacuum is felt to vacuum hose A.
7. If vacuum exists, check the PRC solenoid valve No. 2.
8. Re-connect vacuum hoses A and B.