Transmission Position Sensor/Switch: Adjustments

NOTE: Obtain audio anti-theft access code before disconnecting battery cables.

1. Disconnect the negative battery cable.
2. Remove the resonance duct and the air cleaner housing assembly.
3. Remove the spring pin and clip; and disconnect the selector cable.
4. Rotate the manual shaft to the N position.
5. Disconnect the park/neutral switch connector.
6. Loosen the park/neutral switch mounting bolts.

View: Checking Continuity Between Terminals A & H:

7. Connect an ohmmeter between terminals A and H.
8. Adjust the switch to the point where there is continuity between the terminals.
9. Tighten the park/neutral switch mounting bolts.

Tightening torque: 7.9 - 10.7 Nm (69.5 - 95.4 in.lb.)

10. Verify that the selector lever range position and park/neutral switch are aligned.
11. Connect the park/neutral switch connector.
12. Connect the selector cable and install spring pin and clip.
13. Install the air cleaner housing assembly and the resonance duct.