Air Bag Control Module: Service and Repair

GENERAL PROCEDURES

Before Servicing

1. Deactivate the audio antitheft system, if installed.
2. Disconnect the negative battery cable.
3. Remove the lower panel.





4. Disconnect the orange and blue clock spring connectors.
5. Remove the glove compartment.





6. Disconnect the orange and blue passenger-side air bag module connectors.




DIAGNOSTIC MODULE

Removal / Installation

1. Carry out "Before Servicing" procedure under GENERAL PROCEDURES.






2. Remove in the order shown in the figure.
3. Install in the reverse order of removal.






Follow the troubleshooting flowchart to verify that the air bag system is operating normally.