Parking Mechanism Disassembly/Assembly
PARKING MECHANISM DISASSEMBLY/ASSEMBLY1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly indicated in the table.
Assembly procedure
1. Install the parking pawl.
1) Install the parking pawl and shaft.
2) Install the spring and snap ring.
2. Install the actuator support with new bolts.
Tightening torque
15 - 17 Nm (1.5 - 1.8 kgf-m, 11 - 13 ft-lbf)
3. Install the detent lever and return spring.
4. Install the parking assist lever.
5. Install the lever holder and bolt.
Tightening torque
7.9 - 10.7 Nm
(80 - 110 kgf-cm, 70 - 95.4 in-lbf)
6. Install the manual shaft and manual plate.
1) Install the manual plate, washer, and nut.
2) Tighten the nut to the specified torque.
Tightening torque
42 - 54 Nm (4.2 - 5.6 kgf-m, 31 - 46 ft-lbf)