Door Mirror - Vibration
Bulletin No.: 020/95Issued: 6/16/95
Revised
Category
S
Applicable Models
1993-94 RX-7
Subject:
DOOR MIRROR VIBRATION
APPLICABLE MODELS/VINS
RX-7 model vehicles with a VIN of JM1FD333*R0301491 and lower.
DESCRIPTION
The door mirror may vibrate while driving on bumpy roads. This vibration may be caused by loose mirror mounting screws. To prevent the screws from loosening, a thread locking agent has been added during mass production. Customers complaining of this concern should have the vehicle repaired according to this bulletin.
NOTE: Place a copy of this bulletin in your edition of the NVH manual for future reference.
REPAIR PROCEDURES
1. Verify the complaint.
2. Remove the mirror from the door. Refer to section S of the workshop manual for removal instructions.
NOTE:
Mirror wiring harness removal is not necessary.
3. Apply a non-permanent thread locking compound (Loctite 242 or equivalent) to the three (3) mounting screws and install the mirror.
4. Verify the repair.
WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term Information).
Warranty Type: A
Symptom Code: 83
Damage Code: 9G
Part Number Main Cause: FD01 76 120 ** (Right Door)
FD01 76 180 ** (Left Door)
Quantity: 0
Operation Number: XX0739RX
Labor Hours: 0.3 (both sides)
NOTE:
** in the PNMC designates the applicable color code