Crankshaft Position Sensor: Testing and Inspection

Removal/Installation
1. Remove in the order shown in the figure.
2. Install in the reverse order of removal, referring to Installation Note.




1. Battery cable
2. Drive belt
3. Eccentric shaft pulley
4. Crankshaft position sensor plate
5. Bracket
6. Connectors
7. Crankshaft position sensor (NE-signal)
8. Crankshaft position sensor (G-signal)




Inspection
1. Remove the crankshaft position sensor.
2. Measure the resistance of the sensor.

Resistance: 0.95-1.25 k ohms @ 20°C (68°F)

3. If not as specified, replace the crankshaft position sensor.




Installation Note
Measure the crankshaft position sensor to crankshaft position sensor plate clearance by using feeler gauge.

Clearance: 1.0-2.0 mm (0.039-0.078 in)