Transmission Mode Switch: Service and Repair

Replacement
1. Remove the console panel.
2. Remove the indicator panel screws.




3. Disconnect the shift-lock control unit connector and pull the hold switch terminals out of the connector.
4. Remove the selector lever knob.
5. Install the new selector lever knob.
6. Insert the hold switch terminals into the connector and connect the shift-lock control unit connector.




7. Apply a small amount of locking compound to the screws, and tighten.

Tightening Torque: 1.5-2.9 Nm (14-26 in.lb.)

8. Install and adjust the indicator panel.
9. Install the console panel.