Extension Housing

Assemble in the order shown, referring to Assembly Note.

Assembly note
Oil seal (extension housing)




1. Apply clean oil to the lip and outer edge of a new oil seal.
2. Install the oil seal evenly and gradually by using the SST.

Control rod




1. Install the control rod through the selector and the control rod end, into the extension housing.
2. Install new roll pins into the selector and control rod ends as shown in the image.

Blind cover




1. Apply sealant to the contact surfaces of the blind cover and extension housing.
2. Install the blind cover.

Tightening torque: 19 - 25 N-m (1.9 - 2.6 kgf-m, 14 - 18 ft-lbf)

Control case




1. Apply sealant to the contact surfaces of the extension housing and control case.
2. Install the control case to the extension housing.

Tightening torque: 19 - 25 N-m (1.9 - 2.6 kgf-m, 14 - 18 ft-lbf)