Clutch Housing and Extension Housing

NOTE: The front and rear oil seals do not need to be removed unless you are replacing them.




Disassemble in the order shown in the image, referring to Disassembly Note.

Disassembly note
Extension Housing




1. Temporarily reinstall the shifter lever, and move the control rod end to the neutral position.
2. Remove the shift lever.
3. Remove the extension housing installation bolts.

CAUTION: When removing the extension housing, be careful that the control lever is not pulled into or pushed against the shift rod gates.

4. Lift up on and remove the extension housing from the center housing.