Malfunction Indicator Lamp - A/T: Testing and Inspection

Operational Inspection
1. Turn the ignition switch ON.

NOTE: The hold indicator will flash if a malfunction exists in any of the powertrain control module transmission (PCMT) system components or their circuits.





2. Press the hold switch ON/OFF and verify that the hold indicator illuminates when the hold mode is selected.
3. If not as specified, inspect the combination meter and/or hold switch.

Continuity Inspection
1. Disconnect the negative battery cable.
2. Remove the combination meter.




3. Check for continuity between terminals 5C and 5G of the combination meter.




4. If not correct, replace the bulb or the combination meter.
5. Install the combination meter.
6. Connect the negative battery cable.




Troubleshooting Tip