Replacement

OUTPUT SPEED SENSOR
Replacement
1. Disconnect the negative battery cable.
2. Remove the front exhaust pipe (left side).
3. Disconnect the output speed sensor connector.



4. Remove the output speed sensor.
5. Apply ATF to a new O-ring and install it on the output speed sensor.
6. Install the new output speed sensor.

Tightening torque: 5.0 - 6.8 N.m {50 - 70 kgf.cm, 44 - 60 in.lbf}

7. Connect the output speed sensor connector.
8. Install the front exhaust pipe.
9. Connect the negative battery cable.