Output Speed Sensor

1. Disconnect the negative battery cable.
2. Remove the front exhaust pipe; (left side).
3. Disconnect the Output Speed Sensor connector.
4. Remove the Output Speed Sensor.
5. Apply Automatic Transmission Fluid (ATF) to a new 0-ring and install it on the Output Speed Sensor.
6. Install the new Output Speed Sensor.

Tightening Torque: 5.0-6.8 Nm (44-60 in.lb.)

7. Connect the Output Speed Sensor connector.
8. Install the front exhaust pipe.
9. Connect the negative battery cable.