1. Remove the lower center panel.

2. Remove the data link connector from the bracket.

^ Remove two (2) plastic fasteners.

^ Remove the broken plastic tabs from the bracket screws.

3. Position bracket at the new installation location. Refer to Fig. 2

^ Hold the bracket in its original position. Move the bracket to the left so that the left mounting hole is aligned with the panel installation hole.

^ Remove a portion of the foam area on the center panel around the bracket installation point. Refer to Fig. 2a

NOTE:
This procedure may not be necessary on all vehicles.

^ Use the bracket as a template to mark the new location for the bracket right mounting hole.

^ Drill a 6 mm hole in the lower center panel. Refer to Fig. 2.

4. Use a suitable tool and remove 3mm from the area (round edge only) of the bracket shown in Fig. 3.

5. Install the spring nuts into the bracket. Refer to Fig. 4.

NOTE:
To ensure a tight fit, lightly pinch the spring nuts with pliers prior to installation.

6. Install lower center panel.

7. Install bracket to lower center panel. Refer to Fig. 4.

^ Install a 8mm nut between the inner bracket hole and the panel.

NOTE:
Nut substitutes as a spacer to equalize the distance between the bracket and the recessed portion of the panel.

8. Install data link. Refer to Fig 5.

NOTE:
Ensure direction of data link connector for easy access to NGS tester.

PARTS INFORMATION

WARRANTY INFORMATION

(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term Information)

Warranty Type: A

Symptom Code: 91

Damage Code: 9A

Part Number Main Cause: NA75-60-401G-00 (black) or 88 (black/tan)

Quantity: 0

Operation Number: XX0843RX

Labor Hours: 0.5 Hrs.

DISCLAIMER

Data Link Connector - Falling Off