Shift Lock Actuator

1. Remove the rear console.
2. Remove the selector lever knob and indicator panel screws.
3. Lift up slightly on the selector lever, selector sleeve, and indicator panel, and disconnect the HOLD switch connector.
4. Shift the selector lever to P position.











5. Turn the ignition switch to ON, and check for terminal voltages and continuity, referring to the illustration. Disconnect the shift-lock actuator connector to check continuity between terminal C (harness side) and ground.
6. If not as specified, repair the wiring harness and/or shift-lock actuator.
7. Grasp the HOLD switch wiring harness and pull it while pushing the selector lever knob down fully onto the selector lever.
8. Connect the HOLD switch connector.





9. Adjust the indicator panel. Install the screws in the order shown in the illustration.
10. Apply locking compound to the selector lever knob screw threads after the threads have been cleaned. Tighten the screws to 2.0 - 2.9 Nm (18 - 26 inch lbs.).
11. Install the rear console.
12. Verify correct operation of the shift-lock system.