Operation CHARM: Car repair manuals for everyone.

With Automatic Transaxle (ATX)

REMOVAL / INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the fresh-air duct.

Distributor R & R FS (ATX):




3. Remove in the order shown in the figure.
4. Install in the reverse order of removal, referring to Installation Note.

INSTALLATION NOTE

Installation Note FS:




1. Verify that the No.1 cylinder is at top dead center and the distributor matching marks are aligned.
2. Install the distributor and connect the high-tension leads and distributor connector.
3. Tighten the locknut or bolts to the specified torque.

Tightening torque: 19-25 Nm (14-18 ft.lbs.)