Power Door Lock - Knob Malfunction

Bulletin No.: 022/96
Issued: 11/21/96
Revised:

Category
T

Applicable Model/s
1995-97
626/MX-6

Subject:
POWER DOOR LOCK KNOB MALFUNCTION

APPLICABLE MODELS
1995 - 97 626/ MX-6 without a keyless entry system.

DESCRIPTION

A malfunctioning or inoperative power door lock knob may be caused by a defective power door lock link switch.

Switches are now available as service parts to correct this problem.

Customers complaining of door lock concerns should have the vehicle inspected and if necessary, repaired according to this bulletin.

NOTE:
Due to the availability of the service parts listed, door lock assembly replacement is no longer required to correct this concern.

REPAIR PROCEDURES

1. Verify the complaint.

2. Remove the door trim. Refer to section S of the workshop manual.

NOTE:
Do not remove the door lock at this time.

3. Check the continuity of the door look link switch. Refer to section K2 of the BETM.

^ If the continuity is not as specified, remove the door lock assembly and replace the door lock link switch.

^ If no problem is found with the switch, refer to the workshop manual and BETM for additional troubleshooting information.

NOTE:
When installing the door lock link switch, confirm that the switch is aligned properly.





4. Verify that the lock mechanism operates the link switch when moved.

5. Inspect the spring and actuator rods for damage or misalignment

NOTE:
Replace the spring if damaged, straighten rods if bent.

6. Install the lock mechanism and verify operation.

7. Install door trim panel.





PARTS INFORMATION

WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term Information.)

Warranty Type: A
Symptom Code: 84
Damage Code: 9B
Part Number Main Cause: GC1V-59-312 (MX-6), GC1N-59-312 (626)
Quantity: 1
Operation Number: YY114XRX
Labor Hours: 0.5 Hrs.