Removing the Transaxle Tester

REMOVING THE TRANSAXLE TESTER AND CLEARING DTC

CAUTION: Do not attempt to pry off connectors with a screwdriver. This will cause damage to connector and could result in a transaxle concern.

1. Disconnect the transaxle tester from the solenoid body connector and TSS connector.
2. Reinstall the emission harnesses. Verify the connections by pulling up on the harness.
3. Disconnect the transaxle tester power lead from the vehicle.
4. Erase all DTCs from the continuous test.
5. Rerun the On-Board Diagnostic Test.
6. Based on the transaxle tester testing results, proceed to the appropriate segment of this section for transaxle or electrical/wiring service.
7. Confirm the servicing by repeating transaxle tester test.