Air Flow Meter/Sensor: Service and Repair

INTAKE-AIR SYSTEM COMPONENT PARTS
Removal / Inspection / Installation

WARNING:
^ Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
^ Fuel line spills and leaks are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Pressure Release Procedure".

1. Remove in the order shown in the figure, referring to Removal Note.
2. Inspect all parts and repair or replace as necessary.
3. Install in the reverse order of removal, referring to Installation Note.




1. Fresh-air duct
2. Air cleaner
3. Volume air flow sensor
4. Air intake hose
5. Accelerator cable
6. Fuel pipe
7. Intake manifold
8. Throttle body
9. BAC valve
10. Air intake pipe
11. Fuel distributor




REMOVAL NOTE
Fuel hose

WARNING: Fuel line spills and leaks are dangerous. Fuel can ignite and cause serious injuries or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedures".




Water hose
1. Loosen the drain plug and drain the coolant from the radiator.
2. Remove the water hose from the BAC valve.
3. After installation of the throttle body, refill the radiator.




INSTALLATION NOTE
Air intake pipe
1. Apply a small amount of clean engine oil to new 0-rings before installing them.
2. Install the air intake pipe.

Tightening torque: 7.9-10.7 Nm (70-95.4 in.lbs.)