System Inspection

SYSTEM INSPECTION




1. Connect the special service tools (SST)s new generation star tester (NGS) to the data link connector 2.
2. Warm up the engine to normal operating temperature and let it idle.
3. Select the PID/DATA MONITOR AND RECORD function of the NGS.
4. With no electrical load operating, select "INJ RH" and "INJ LH" on the NGS display. NGS measures and shows the fuel injector pulse widths.
5. Increase the engine speed and verity that the pulse width changes.
6. If signal cannot be detected, or shows no change, check voltage at following terminals
- ECM terminal 3E (Mass air flow sensor)
- ECM terminal 4AH 4AL (Crankshaft position sensor)

FUEL CUT
Inspection
Without using SST-(NGS)
1. Warm up the engine to normal operating temperature and let it idle.
2. Turn off the A/C switch.
3. Connect a tachometer to the data link connector terminal IG-.
4. Open the throttle valve and increase the engine speed to 4,000 rpm.




Check each fuel injector operation by using a sound scope or a screwdriver.
5. Close the throttle valve quickly. Verify that no fuel injector operating sound is heard while decreasing engine speed to approx. 1,200 rpm.
6. If not as specified, check voltage at following terminals.
- ECM terminal 3Q (Engine coolant temperature sensor)
- ECM terminal 3X (Closed throttle position switch)

Inspection
Using SST-(NGS)
1. Connect the SST-(NGS) to the data link connector.
2. Warm up the engine to normal operating temperature and let it idle.
3. Turn OFF the A/C switch.




4. Select the PID/DATA MONITOR AND RECORD function of the NGS.
5. Select "INJ RH" and "INJ LH" on the NGS display. NGS measures and shows the fuel injector pulse width.
6. Open the throttle valve and increase the engine speed to 4,000 rpm.
7. Close the throttle valve quickly. Verify that the fuel injector pulse width becomes O milliseconds until the engine speed drops to approx. 1,200 rpm, then recovers after that.
8. If not as specified, check voltage at following terminals.
- ECM terminal 3Q (Engine coolant temperature sensor)
- ECM terminal 3X (Closed throttle position switch)
- ECM terminal 4AH, 4AL (Crankshaft position sensor)

DECHOKE
Inspection
1. Turn the ignition switch to START and verify that the engine start or ignition occur while cranking.




2. Depress the accelerator pedal to the wide open throttle and turn the ignition switch to START. Verify that no injector operating sound is heard while cranking by using a sound scope or screwdriver.
3. If not as specified, check the ECM terminal 3B voltage. (Throttle position sensor)