Clearing Trouble Codes

After-Repair Procedure

View: SST-NGS Tool Menu:

1. Cancel the diagnostic trouble code memory by using the SST-New Generation Star Tester.
(Refer to Instruction Manual)
2. Remove the SST from the data link connector 2.




3. Drive the vehicle at 50 km/h (31 mph), and depress the accelerator pedal fully to activate kickdown. Stop the vehicle gradually.




4. Re-connect the SST to the data link connector 2 and battery.
5. Turn the ignition switch ON.
6. Verify that NO diagnostic trouble codes are displayed.