Transmission Speed Sensor: Service and Repair
Replacement1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly, battery and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new 0-ring and install it on a new input/ turbine speed sensor.
6. Install the input/turbine speed sensor.
Tightening torque: 5.4-7.8 Nm (47-69 in.lb.)
7. Connect the input/turbine speed sensor connector.
8. Install the battery and battery carrier, air cleaner assembly.
9. Connect the negative battery cable.