Component Tests and General Diagnostics

Inspection of Resistance
1. Refer to "Replacement" below to disconnect the input/turbine speed sensor connector.
2. Measure resistance between the terminals of the input/ turbine speed sensor.

Resistance: 253-604 ohms [ATF temperature: -40-160°C (-40-320°F)]

3. If not correct, replace the input/turbine speed sensor.
4. Refer to "Replacement" to connect the input/turbine speed sensor connector.




Inspection of Wave Form
1. Connect the oscilloscope to the powertrain control module at terminals 2P and 2T.
2. Inspect the wave form as shown in the figure above.




Replacement
1. Disconnect the negative battery cable.
2. Remove the air cleaner assembly, battery and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new 0-ring and install it on a new input/ turbine speed sensor.
6. Install the input/turbine speed sensor.

Tightening torque: 5.4-7.8 Nm (47-69 in.lb.)

7. Connect the input/turbine speed sensor connector.
8. Install the battery and battery carrier, air cleaner assembly.
9. Connect the negative battery cable.