Engine Control Module: Service and Repair

POWERTRAIN CONTROL MODULE (PCM)
Removal / Installation
1. Disconnect the negative battery cable.
2. Remove the rear console box, center panel and under cover.
3. Remove in the order shown in the figure, referring to Removal note.
4. Install in the reverse order of removal, referring to Installation note.




1. Cover
2. PCM bracket screw
3. PCM bracket nut
4. Connector
5. PCM




Removal note
Connector
1. Remove the rear heater duct fasteners.
2. Separate the rear heater duct to both sides.

NOTE: Separating the duct may cause deformation to it. However, this will not affect the performance of the duct.

3. Disconnect the PCM connector.

Installation note
Connector
1. Connect the PCM connector.
2. Assemble the rear heater duct.
3. Verify that the rear heater duct is correctly joined, and install the rear heater duct fasteners.