With EC-AT Tester (49 GO19 901B)

Inspection Using EC-AT Tester (49 G019 901B)

Assembly Of Special Service Tools:

1. Assemble the special service tools (SST)s as shown above.

View: Control Switch Locations:

2. Set the EC-AT selector switch to position 3.
3. Set the EC-AT tester vehicle switch to 626/MX-6 position.
4. Set the EC-AT tester select switch to position A.
5. Turn the ignition switch and the EC-AT tester main switch to ON.
6. Check the indication of the respective light or digital display in each condition, referring to the indication table below.

Indication Table Of Light And Digital Display: