Keyless Entry - Security Installation Procedures: Overview

Bulletin No.: 003/96
Issued: 02/07/96
Revised:

Category
T

Applicable Model/s
1996 Protege

Subject
KEYLESS ENTRY/SECURITY INSTALLATION PROCEDURES

APPLICABLE MODELS

All 1996 Protege models (LX and ES Models Only)

DESCRIPTION

The wiring harness for the power door lock relay has changed for the 1996 Protege. This change affects the installation procedures (Steps 17 and 18) supplied with the Keyless Entry/Security system for 1996 Protege models.

USE THIS INFORMATION:

1. ONLY when installing the Keyless Entry/Security system on 1996 Protege models.

2. To perform Steps 17 and 18 (Door Lock Connection) instead of the existing steps (17 and 18 only).

3. If a customer complains of door lock functions after a kit was installed (i.e. prior to this Service Bulletin).

CAUTION:
An intermediate 8-pin connector was incorporated on early production 1996 Protege Models.

This connector is located approximately 6 inches from the door lock relay. This connector has
been eliminated during the latest production. THIS CONNECTOR CHANGES THE INSTALLATION METHOD for the "Keyless Entry/Security" kit.
Prior to kit performing the attached new steps (17 and 18), verify the level of the production unit.

PARTS INFORMATION

Part Number Description

0000 88 SECR PR Keyless Entry/Security