Idle Up Speed

PREPARATION
- Warm up the engine to normal operating temperature.
- Shift the transaxle into Neutral (MTX) or P position (ATX).
- Turn off all loads.
- Headlight
- Blower motor
- Rear window defroster
- Power steering
- Wait until the cooling fan stops.
- Connect the SSTs (NGS) to the data link connector-2 and select the PID/DATA MONITOR AND RECORD function.
- Select the "RPM" on the NGS display.

IDLE UP SPEED
- Perform "Preparation".
- Verify that the idle speed is within the specification.

Specification: 700 - 800(750 ± 50) rpm

- If not as specified, adjust the idle speed.
- Check the idle speed with the following load conditions.




NOTE: Excludes temporary idle speed drop just after the electrical loads are turned on.

- If not as specified with all load condition, inspect the idle air control valve. If not as specified with each load condition, check related input switches, harnesses and connectors.