Fuel Pressure Sensor/Switch: Service and Repair

REMOVAL/INSTALLATION
Fuel Tank Side
- Remove the fuel tank.
- Remove in the order shown in the figure.
- Install in the reverse order of removal, referring to Installation note.




1. Rollover valve
2. Tank pressure control valve (TPCV)
3. Fuel tank pressure sensor
4. Check valve (two-way)
5. Charcoal canister
6. Air filter
7. Canister drain cut valve (CDCV)




INSTALLATION NOTE
Rollover Valve, Check Valve (two-way), Tank Pressure Control Valve, Charcoal Canister
Push the ends of the evaporative hoses onto respective fittings.

Specification:
15 - 20 mm (0.60 - 0.78 in) (except charcoal canister)
25 - 30 mm (0.99 - 1.18 in) (charcoal canister)

Check Valve (two-way)
- Push the end of the evaporative hose onto the fitting.

Specification: 15 - 20 mm (0.60 - 0.78 in)

- Install the check valve (two-way) in the correct direction as shown.