Clearing Trouble Codes

AFTER-REPAIR PROCEDURE
1. Cancel the diagnostic trouble code memory by using the SST (NGS).
2. Remove the Special Service Tools (SST)s New Generation Star (NGS) tester from the data link connector 2.
3. Drive the vehicle at 50 km/h (31 mph), and depress the accelerator pedal fully to activate kickdown. Stop the vehicle gradually.
4. Connect the SST (NGS) to the data link connector 2 and battery.
5. Turn the ignition switch to ON.
6. Verify that no diagnostic trouble codes are displayed.
7. Remove the SST from the data link connector 2.

DTC Index:

NOTE: If a diagnostic trouble code is shown on the SST, check for the cause by using the chart related to the code shown.