Tilt Wheel Switch: Service and Repair

REMOVAL
1. Remove the combination switch.
2. Follow the removal steps outlined in the illustration, noting the following.





3. Remove the screws.
4. Release the tabs of the tilt switch from the turn lever boot.
5. Slide the tilt switch in the direction indicated by the arrow, then remove it along the turn lever.

INSTALLATION
1. Follow removal procedure in reverse order for installation.





2. After installing the tilt switch, route the harnesses of the combination switch as shown.





3. Set the harness length from the shaft contact portion as follows:
^ 4-pin connector, 1 pin connector, 2 pin connector: 415 - 435 mm (16.4 - 17.1 inch).
^ 4-pin connector (tilt switch), 21-pin connector: 270 - 290 mm (10.7 - 11.4 inch).





4. Install the band, band clip, and vinyl tape as shown.
^ A: 125 - 130 mm (4.92 - 5.11 inch).
^ B: 70 - 75 mm (2.76 - 2.95 inch).
^ C: 20 - 25 mm (0.79 - 0.98 inch).