Using the EC-AT Tester (49 G01 901C)

ELECTRICAL SIGNAL INSPECTION PROCEDURE

CAUTION: Do not connect the NGS to the data link connector 2 when the EC-AT tester is connected to the transaxle control module. Doing so can cause incorrect test results.




When Using The EC-AT Tester (49 G019 901C)
1. Assemble the Special Service Tool.




2. Turn the EC-AT tester select switch to the mark on the panel.
3. Turn the ignition switch and the EC-AT tester main switch to ON.




4. Check the indication of the respective light or digital display in each condition, referring to the indication table.