Using the EC-AT Tester (49 G019901)

ELECTRICAL SIGNAL INSPECTION PROCEDURE

CAUTION: Do not connect the NGS to the data link connector 2 when the EC-AT tester is connected to the transaxle control module. Doing so can cause incorrect test results.




When Using The EC-AT Tester (49 G019 901) And Adapter Unit (49 H019 902)
1. Assemble the Special Service Tool.




2. Set the EC-AT selector switch to position 3.
3. Set the adapter unit vehicle switch to 626/MX-6 position.
4. Set the adapter unit select switch to position A.




5. Turn the ignition switch and the EC-AT tester main switch to ON.




6. Check the indication of the respective light or digital display in each condition, referring to the indication table.