Engine Tightening Specifications

Intake:

1. Dynamic Chamber Cover
2. Charge Air Cooler Air Duct
3. Air Cleaner Assembly
4. Air Duct
5. Fresh-Air Duct
6. Mass Air Flow Sensor
7. Air Intake Hose
8. Resonator
9. Charge Air Cooler (RH)
10. Charge Air Cooler (LH)
11. Air Hose
12. Accelerator Cable
13. EGR Valve
14. Air Intake Pipe Assembly

Torque Sequence:

Upper Engine:

Cam Cap Torque/Sequence:

Tighten the cylinder head bolts as described below.
1) Before installation, measure the length of each bolt. Replace any that exceed the maximum length.

Length:
133.7 - 134.3 mm (5.264 - 5.287 inch)
Maximum:
135.0 mm (5.315 inch)

Torque Sequence:

2) Apply clean engine oil to the threads and the seat face of each bolt and install them.
3) Tighten the bolts in two or three steps in the order shown.

Torque Sequence:

Tightening torque:
23.1 - 25.9 Nm (17.0 - 19.1 ft. lbs.)

Lower Engine:

Lower Cylinder Block Torque Sequence:

Torque Sequence:

Lower Cylinder Block Torque Sequence:

Flex Plate mounting Bolts 61 - 67 Nm (45 - 49 ft. lbs.)