Headlamp: Adjustments
Vertical-Horizontal Aiming Method1. Adjust the air pressure of the tires to the specification.
2. Fill the fuel tank and remove excess cargo.
3. Position the unloaded vehicle on a flat, level surface.
4. Position the vehicle straight ahead and perpendicularly to a wall. Set the distance between the headlight and the wall to 7.6 m (25 ft).
5. Disconnect the connector of the other headlight.
6. Adjust the up/down position of the headlight by using the vertical aiming gauge. Make sure the bubble in the gauge is within two lines on either side of the center "0".
7. Pull up the clip.
8. Push gear A toward the front of the vehicle until gears A and B disengage.
9. Turn the headlight on at low beam.
10. By using a screwdriver, turn gear B to carry out horizontal aiming. The left edge of the figure projected on the wall screen must be aligned with the vertical axis as shown.
11. Turn gear A to align the aiming points.
12. Push the clip down until gears A and B engage.
13. Do this procedure for both RH and LH headlights.
NOTE: When the headlights are correctly adjusted by following the above steps, simplified aiming by just turning gear B to align aiming points is possible.