Vehicle Speed Sensor: Service and Repair

REPLACEMENT
1. Disconnect the negative battery cable.
2. Remove the battery.
3. Disconnect the output speed sensor connector.
4. Remove the splash shield.




5. Remove the output speed sensor.
6. Apply ATF to a new 0-ring and install it on the output speed sensor.
7. Install the new output speed sensor

Tightening torque: 5.0-6.8 Nm (44-60 in.lbs.)

8. Install the splash shield.
9. Connect the output speed sensor connector.
10. Install the battery.
11. Connect the negative battery cable.