Front

REMOVAL
1. Remove the splash shield(s).
2. Follow the removal steps outlined in the illustration, noting the following steps.





3. Support the crossmember by using a jack.
4. Remove the crossmember installation bolts and nuts.
5. Lower the crossmember to gain clearance.
6. Remove the stabilizer bracket.





INSPECTION
Stabilizer control link
1. Inspect for bending and damage.
2. Measure the ball joint starting torque.
a. Shake the ball joint stud from side to side 10 times.
b. Rotate the ball joint stud 10 times.
c. Measure the starting torque by using an Allen socket and a torque wrench.
3. If not within 0.1 - 1.9 Nm (0.9 - 17 inch lbs.), replace the stabilizer control link.

INSTALLATION
1. Follow the removal steps in reverse order as outlined in the illustration for installation, noting the following steps.





2. Apply rubber grease to the inside surface of the stabilizer bushing.
3. Align the bushing with the stopper on the stabilizer.
4. Adjust the front wheel alignment.
5. Bleed the air from the power steering system.