Electrical Signal Inspection

CAUTION: Do not connect the NGS to the data link connector 2 when the EC-AT tester is connected to the transaxle control module. Doing so can cause incorrect test results.











WHEN USING THE EC-AT TESTER (49 G019 901 ) AND ADAPTER UNIT (49 H019 902), AND ADAPTER UNIT (49 L019 901) OR ADAPTER UNIT (49 L019 901A)
1. Assemble the Special Service Tool (SST).
2. Set the SST (49 H019 902 and 49 L019 901A) vehicle switch to 929 position.
3. Turn the ignition switch and EC-AT tester main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to the indication table illustrated.











WHEN USING THE EC-AT TESTER (49 G019 901 B) AND ADAPTER UNIT (49 L019 901) OR ADAPTER UNIT (49 L019901 A)
1. Assemble the SST.
2. Set the SST (49 G019 901 B and 49 L019 901 A) vehicle switch to 929 position.
3. Turn the ignition switch and the EC-AT tester main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to the indication table illustrated.











WHEN USING THE EC-AT TESTER (49 G019 901 C)
1. Assemble the SST.
2. Turn the SST select switch to the black triangle mark on the panel.
3. Turn the ignition switch and the SST main switch to ON.
4. Check the indication of the respective light or digital display in each condition, referring to the indication table illustrated.