D Range Test

NOTE: There is TCC non-operation in the following conditions.
a. The engine coolant temperature is below 60°C (140°F).
b. The closed throttle position switch is ON.
c. The brake switch is ON.






D RANGE (EXCEPT HOLD)
1. Shift the selector lever to D range.

NOTE: There is no shift to fourth gear in any of the following conditions.
a. The ATF temperature is below 10°C (50°F).
b. The cruise control is operating, and there is an 8 km/h (5 MPH) difference between the preset cruise speed and the vehicle speed.

2. Accelerate the vehicle to half- and full-throttle opening.
3. Verify that 1->2, 2->3, and 3->4 upshifts and downshifts are obtained. The shift points must be as shown in the table concerning vehicle speed at shift point.
4. Drive the vehicle in fourth, third, and second gear and verify that kickdown occurs for 4->3, 3->2, 4->1, 3->2, 3->1, 2->1, and that the shift points are as shown in the table concerning vehicle speed at shift point.
5. Drive the vehicle and verify that TCC operation is obtained.

D RANGE (HOLD)
1. Select HOLD mode.
2. Accelerate the vehicle to half- and full-throttle opening, and verify that 2->3 upshift and downshift are obtained. The shift points must be as shown in the table concerning vehicle speed at shift point.
3. Drive the vehicle in third and second gear and verify that kickdown does not occur.
4. Decelerate the vehicle and verify that engine braking effect is felt in second and third gear.
5. Drive the vehicle and verify that TCC operation is obtained.