Using the New Generation Star Tester

1. In the passenger compartment, connect the Special Service Tool New Generation Star (NGS) tester to the data link connector 2 as shown in the figure.




2. Referring to the NGS operational manual, select the "PID DATA MONITOR AND RECORD" and press TRIGGER.

NOTE:
- The PID DATA MONITOR function is to monitor the calculation value of input/output signals in the PCM. Deviation in the value does not always indicate malfunction in the related input/output devices (sensors and solenoids).
- For inspection of the input/output signals other than listed below, check voltage at the applicable PCM terminal by using the Special Service Tool (Engine Signal Monitor).

3. Press CLEAR to clear previously select items. (A list of item descriptions appears on the screen.)
4. Select items necessary and press START.
5. Carry out inspection referring to PID/DATA MONITOR image.
6. If normal output signal cannot be detected when all input signals are normal, replace the PCM.










PID/DATA MONITOR Charts