Overhaul

PRECAUTIONS
- Clean the transaxle exterior thoroughly with a steam cleaner or cleaning solvent before disassembly.

WARNING: Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed air.

- Clean the removed parts (except sealed bearings) and all sealing surfaces with cleaning solvent, and dry with compressed air.
- Clean out all holes and passages with compressed air, and verify that there are no obstructions.
- Replace all O-rings and gaskets with the new ones included in the overhaul kit.
- Verify that all parts are completely cleaned before assembly.
- Assemble parts within 10 minutes after applying sealant. Allow all sealants to cure for at least 30 minutes after assembly before filling the transaxle with transaxle oil.
- Replace bearing races and bearings as sets.

OVERHAUL COMPONENTS
- 5th/Reverse and housing parts Service and Repair
- Clutch housing and transaxle case components Service and Repair
- Primary shaft assembly Service and Repair
- Secondary Shaft Assembly Service and Repair