Rearview Mirror Removal and Installation
MIRROR REMOVAL1. Insert a flathead screwdriver between the mirror and the base.
2. Push the base pin to remove the mirror.
MIRROR INSTALLATION
^ Install the rearview mirror onto the base.
BASE REMOVAL
1. Wind each end of a wire around a bar.
2. Saw through the sealant, using a long sawing action to spread the work over the whole length of wire to prevent it from breaking.
BASE INSTALLATION
1. Cut away all of the original sealant by using a razor knife.
2. Clean and degrease the glass.
3. Apply primer onto the bonding area of the glass and the base by using a brush. Use only glass primer on the glass and body primer on the base. Keep the bonding area free of dirt and grease and do not touch the surface. Allow the primer to dry for approximately 30 minutes.
4. Apply a 3 mm (0.12 in) bead of sealant to the base.
5. Center the base in the ceramic coating and press it onto the glass. Use white gasoline to remove any excess sealant.
Hardening time of sealent