Transmission Speed Sensor: Testing and Inspection

INPUT/TURBINE SPEED SENSOR
Inspection of resistance:
1. Disconnect the negative battery cable.
2. Remove the battery, air cleaner assembly, and battery carrier.
3. Disconnect the input/turbine speed sensor connector.
4. Measure the resistance between the terminals of the input/turbine speed sensor.

Resistance: 200 - 400 ohms (ATF temperature: -40 - 160°C (-40 - 320°F)

5. If not correct, replace the input/turbine speed sensor.
6. Connect the input/turbine speed sensor connector.
7. Install the battery carrier, air cleaner assembly, and battery.
8. Connect the negative battery cable.